
A full sweep of the flue, firebox and smoke chamber — creosote gone, draft restored, and a written condition report before we leave.
Every fire leaves something behind. Creosote — the tar-like residue that coats the inside of a flue — builds up a little more with each burn, and it is the single most common cause of chimney fires in Pennsylvania homes. A professional sweep strips that buildup out of the flue, clears the smoke chamber and firebox, and gives a trained eye the chance to spot cracked tiles, worn mortar and failing parts while they are still cheap to fix.
Our sweep is not a quick brush-and-go. We seal off the fireplace opening, protect the room with drop cloths and a HEPA vacuum running the whole visit, work the flue from top to bottom with rods and brushes sized to your liner, and finish with a condition check of the parts we can see. You get a straight answer about the state of your chimney — what is fine, what to watch, and what genuinely needs attention.
Tell us about your chimney or gas fireplace — we confirm every request by phone. Prefer to talk? Call (855) 424-6217.
The working rule is once a year for any chimney that sees regular use — and in Philadelphia rowhomes and Delaware Valley homes that burn two or three nights a week through the heating season, annual is not conservative, it is simply right. Wood type matters too: pine and unseasoned wood, both common in firewood deliveries around the metro, lay down creosote far faster than dry oak or maple. If you burn more than a cord a season, ask us to check the buildup rate at your first sweep and we will set a schedule that fits how you actually use the fireplace.
We start at the roof: cap off, flue inspected from above, then the sweep itself, working down into the smoke chamber and firebox. Ash and debris are vacuumed as we go, the damper is cleaned and checked for a proper seal, and we finish inside with a look at the firebox brick and mortar. Most single-flue sweeps take about an hour. If we find something — a cracked liner tile, a rusted damper, a crown that is letting water in — you will see the photo and hear the options before any decision is made.
We provide chimney sweep in every community we serve — including Philadelphia · Bensalem · Norristown · Upper Darby · Levittown · West Chester · Doylestown — and all 165 towns in our service area.
A standard single-flue sweep takes about an hour. A chimney that has not been cleaned in years, or one with heavy glazed creosote, can take longer — we will tell you what we are dealing with as soon as we see it.
No. We seal the fireplace opening, lay drop cloths and run a HEPA vacuum during the entire job. The soot stays in our equipment, not on your furniture.
Yes — once the sweep is done and we have confirmed nothing unsafe turned up, you can light a fire the same evening.
Yes. We sweep flues serving wood stoves, fireplace inserts and pellet stoves, and we clean the appliance connection as part of the visit.
That is common — especially in houses that sat vacant, were used as rentals, or waited through a long estate sale. We will sweep it, document the condition and tell you plainly whether it is safe to burn or needs repair first.
Level 1 and Level 2 chimney inspections with camera scanning, a photo report and straight answers — for annual checks, home sales and after a chimney fire.
Learn more →
The annual inspection for chimneys in regular service: every accessible part checked, condition documented, safety confirmed for another season.
Learn more →
Camera inspection of the entire flue, plus attics, crawl spaces and concealed areas — the inspection for home sales, chimney fires and appliance changes.
Learn more →
Gas fireplace cleaning, safety checks and repair — pilot and ignition problems, weak flames, sooting glass and units that will not stay lit.
Learn more →